Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › NETWORK GATEWAY ECU

NETWORK GATEWAY ECU > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH


2. REMOVE COWL SIDE TRIM BOARD LH


3. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER LH


    B066070E01
  1. Remove the 2 bolts <A>.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the 2 claws and 3 clips, and then remove the instrument panel finish panel sub-assembly lower LH.

  1. Disconnect the connectors.



4. REMOVE INSTRUMENT PANEL SAFETY PAD INSERT NO. 1


    B066071E01
  1. Remove the 4 bolts <A> and instrument panel safety pad insert sub-assembly No. 1.

  1. Disconnect the connector.



5. REMOVE CLEARANCE WARNING ECU ASSEMBLY


    E146348
  1. Disconnect each connector.

  1. Remove the nut and clearance warning ECU.



6. REMOVE NETWORK GATEWAY ECU
  1. Disconnect each connector.



    C161438
  1. Remove the nut and network gateway ECU.