Home › COMMUNICATION SYSTEM › CAN COMMUNICATION › CAN COMMUNICATION SYSTEM

CAN COMMUNICATION SYSTEM > FAIL-SAFE CHART

for Preparation Click here



FAIL-SAFE FUNCTION
  1. When communication fails in any of the main wires (communication lines) due to a short circuit or other causes, the fail-safe function, which is specified for each system, operates to prevent the system from malfunctioning.

  2. The table below shows the effects on each system when communication is impossible. For further details, refer to each system.

    Function
    ECM
    Network Gateway ECU
    Skid control ECU with Actuator
    Yaw Rate Sensor
    Steering Angle Sensor
    Distance control ECU
    Condition when communication impossible
    DTC detection (Driver detectable)
    VSC control
    B
    -
    A
    B
    B
    -
    1. ABS control stops
    2. VSC control stops
    3. Traction control stops
    1. VSC warning light illuminates
    2. ABS warning light illuminates
    3. Brake warning light illuminates
    4. Slip indicator illuminates
    Dynamic laser cruise control
    B
    -
    B
    B
    B
    A
    Dynamic laser cruise control stops
    CRUISE main indicator illuminates
    Air conditioning control
    B
    A
    (Air conditioning system)
    -
    -
    -
    -
    Air conditioning stops
    No indicators or buzzers illuminate
    Meter display
    B
    A
    (Meter)
    B
    -
    -
    -
    Light does not come on or remains on
    Light does not operate normally

    HINT:
    1. A: Main control judgment system
    2. B: Location where necessary control information is input