Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Rear Air Conditioning Control Panel Circuit

for Preparation Click here


DESCRIPTION

This is the rear A/C system control signal circuit as well as the power supply circuit of the rear A/C control assembly.
Pulse signals regarding rear A/C control panel switch operation are transmitted between the A/C amplifier and rear A/C control assembly.

WIRING DIAGRAM


E147373E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (REAR A/C CONTROL ASSEMBLY - BATTERY)


    E147478E01
  1. Disconnect the connector from the rear A/C control assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    R18-9 (IG) - Body ground
    Ignition switch: ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (REAR A/C CONTROL ASSEMBLY - BODY GROUND)


    E147478E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    R18-6 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (REAR A/C CONTROL ASSEMBLY - A/C AMPLIFIER)


    E147479E01
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    R18-2 (BLK) - A10-11 (BLK)
    Always
    Below 1 Ω
    R18-3 (STX) - A10-10 (STX)
    Always
    Below 1 Ω
    R18-4 (CLK) - A10-9 (CLKR)
    Always
    Below 1 Ω
    R18-5 (DPD) - A10-8 (DPD)
    Always
    Below 1 Ω
    R18-10 (SWD) - A10-7 (SWD)
    Always
    Below 1 Ω
    R18-2 (BLK) - Body ground
    Always
    10 kΩ or higher
    R18-3 (STX) - Body ground
    Always
    10 kΩ or higher
    R18-4 (CLK) - Body ground
    Always
    10 kΩ or higher
    R18-5 (DPD) - Body ground
    Always
    10 kΩ or higher
    R18-10 (SWD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE