Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > Rear Air Conditioning Relay Circuit

for Preparation Click here


DESCRIPTION

The RR A/C relay is switched on by signals from the A/C amplifier. It supplies power to the rear blower motor.

WIRING DIAGRAM


E147374E01


INSPECTION PROCEDURE

1.INSPECT RELAY (RR A/C)


    E148195
  1. Remove the RR A/C relay from the No. 3 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Always
    Below 1 Ω
    3 - 4
    When battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Always
    10 kΩ or higher
    3 - 5
    When battery voltage applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE RELAY (RR A/C)
OK


2.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY)


    E147476E04
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A9-8 (HRH) - Body ground
    Ignition switch: ON
    Rear blower control dial: OFF
    11 to 14 V
    A9-8 (HRH) - Body ground
    Ignition switch: ON
    Rear blower control dial: ON
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE