Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1442/44    Invalid Data Received from Deceleration Sensor

DTC    C1443/34    Invalid Data Received from Yaw Rate Sensor

for Preparation Click here


DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
The yaw rate sensor has a built-in deceleration sensor and detects the vehicle condition.

DTC Code
DTC Detection Condition
Trouble Area
C1442/44
With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the deceleration sensor for 10 seconds or more.
Yaw rate and deceleration sensor
C1443/34
With terminal IG1 voltage between 9.5 and 17.4 V, an invalid data signal is received from the yaw rate sensor for 10 seconds or more.
Yaw rate and deceleration sensor

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and deceleration sensor, perform zero point calibration (Click here).

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Start and idle the engine for 60 seconds, and then stop the engine.

  1. Check if the same DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTCs (C1442/44 and/or C1443/34) are output
    A
    DTCs (C1442/44 and C1443/34) are not output
    B



B
CHECK FOR INTERMITTENT PROBLEMS
A

REPLACE YAW RATE AND DECELERATION SENSOR