Home › Vehicle Exterior › BODY PANEL › FRONT BODY PILLAR
BM3650E _01 Vehicle Exterior _083396 BODY PANEL _0402522 FRONT BODY PILLAR F

BODY PANEL  FRONT BODY PILLAR  CUT AND JOIN REPLACEMENT SECTIONS (SMALL AREAS)  


K153140

REMOVAL


Symbol Meaning
K108818

Remove Weld Points
K108827

Cut and Join Location

a.

Mark and perform the separating cuts to match the specified dimensions.

NOTICE:

Thereby disconnect only the outer panel.



b.

Remove the weld points in areas (1).

K152771C01
2.531,0.594 2.844,0.75 0.313,0.156 10 false *a 4.792,1 5.104,1.156 0.313,0.156 10 false *b 4.646,2.292 4.958,2.448 0.313,0.156 10 false *b 2.719,2.083 3.031,2.24 0.313,0.156 10 false *a
*a 80 mm (3.15 in.) from the outer edge of the hole *b 30 mm (1.18 in.) from the outer edge of the hole




INSTALLATION


Symbol Meaning
K108823

Plug Weld
K108831

Butt Weld

a.
K152772C01
0.417,0.75 0.583,0.75 0.583,0.75 1.094,1.26 false 0.25,0.667 0.563,0.823 0.313,0.156 10 false *1
*1 SIDE PANEL SUB-ASSY OUTER


Position the front body pillar section.


b.

Weld the side panel sub-assy outer in areas (1).


c.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.