REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut Location |
The operations shown only for one side must be carried out on both sides.
Remove the welding points in areas (1).
Bend the rear light housing slightly upwards in the marked area in the direction of arrow.
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
The operations shown only for one side must be carried out on both sides.
Adjust and secure the inner rear trim panel in combination with the tailgate.
| *1 | BODY LOWER BACK PANEL REINFORCEMENT INNER |
Weld the body lower back panel reinforcement inner to the vehicle side.
Adjust and secure the tail panel in combination with the tailgate and rear lights.
Bend back rear light housing in the area (1).
Weld the body lower back panel sub-assy to the vehicle side.
| *1 | BODY LOWER BACK PANEL SUB-ASSY | - | - |
Weld coarse thread bolt (1) on the rear trim panel.
Take the quantity and position from the component to be replaced
Weld coarse thread bolt (1) on the rear trim panel.
Take the quantity and position from the component to be replaced
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.