REMOVAL
| Symbol Meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
Remove the weld points in areas (1) and (2).
Remove the weld points in areas (1).
To provide a better overview: Shown without side panel and without tail panel.
Remove the rear floor side panel extension.
PREPARE NEW PART
| *1 | REAR FLOOR PAN EXTENSION (LH) |
| *2 | REAR FLOOR SIDE PANEL EXTENSION (RH) |
Remove the weld points in areas (1).
Remove (2) from the new parts of rear floor pan extension or rear floor side panel extension (3).
Adjust (3) on the vehicle.
INSTALLATION
| Symbol Meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
| *1 | REAR FLOOR PAN EXTENSION (LH) |
| *2 | REAR FLOOR SIDE PANEL EXTENSION (RH) |
Insert and secure rear floor pan extension or rear floor side panel extension from below.
Weld the rear floor pan extension or rear floor side panel extension in the area (1).
Weld the rear floor pan extension or rear floor side panel extension in areas (1) and (2).
Weld the coarse thread bolt (1) on the new part.
Take the quantity and position from the component to be replaced.
Weld the coarse thread bolt (1) on the new part.
Take the quantity and position from the component to be replaced.
After welding, apply body sealer and undercoating to the corresponding parts. (See the painting/coating)