Measure points with the front fender upper protector insulator removed.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Rivet nut of upper front wheel arch carrier support | M10 (0.39) |
| B, b | Hole for front spring support | φ9 (0.35) |
| C, c | Corner of tab on front carrier support | - |
| D, d | Blind rivet nut on mounting of inside trim panel | M6 (0.24) |
| *a | mm
(in.) |
- | - |