Home › Vehicle Exterior › BODY DIMENSIONS › BACK DOOR
BM3650E _01 Vehicle Exterior _083398 BODY DIMENSIONS _0402543 BACK DOOR F

BODY DIMENSIONS  BACK DOOR  POINT-TO-POINT DISTANCE  


HINT:
·

Point F, f on the vehicle are asymmetrical.

·

In cases in which only one dimension is given, left and right are symmetrical.

·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A, a Corner of upper side frame -
B, b Corner of centre of side frame -
C, c Corner of lower side frame -
D, d Bolting point of outer rear light φ9 (0.35)
E, e Bolting point of inner rear light φ9 (0.35)
F, f Bolting point of striker M8 (0.31)
G, g Mounting of upper impact absorber M12 (0.47)

K143695

Symmetric distance
K143696

Asymmetric distance

K151970C05
0.083,8.594 0.396,8.75 0.313,0.156 10 false *a 1.188,6.927 1.5,7.083 0.313,0.156 10 false *W 3.573,6.927 3.885,7.083 0.313,0.156 10 false *L 3.573,7.698 3.885,7.854 0.313,0.156 10 false *X
*a mm
(in.)
- -
*W Width distance *L Length distance
*X Diagonal distance - -


HINT:
·

Point D, d on the vehicle are asymmetrical.

·

In cases in which only one dimension is given, left and right are symmetrical.

·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A Mounting of partition wall trim panel - centre of vehicle φ12 (0.47)
B, b Mounting of upper inner impact absorber -
C, c Hole for holding clip for wiring harness on wheel arch φ6.5 (0.26)
D, d Bolting point of striker M8 (0.31)

K143695

Symmetric distance
K143696

Asymmetric distance

K151971C03
0.083,8.594 0.396,8.75 0.313,0.156 10 false *a 3.167,7.031 3.479,7.188 0.313,0.156 10 false *X
*a mm
(in.)
- -
*X Diagonal distance - -