In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Hole for front engine support | φ20 (0.79) |
| B, b | Bolting point of front axle support on front section of body | M12 (0.47) |
| C, c | Bolting point of front axle support on centre section of body | M12 (0.47) |
| D, d | Bolting point of front axle support on rear section of body | M14 (0.55) |
| E, e | Bolting point of front axle support on rear outer section of body | M12 (0.47) |
| F, f | Hole for rear engine support | φ20 (0.79) |
| G, g | Hole for rear engine support | φ20 (0.79) |
| H, h | Compression strut, front, to body | M10 (0.39) |
| J, j | Rear axle support on front section of body | M12 (0.47) |
| K, k | Rear axle support on rear section of body | M12 (0.47) |
| L, l | Rear silencer holder on rear section of body | M8 (0.31) |
| M, m | Corner of mounting of lower front impact absorber | - |
| *a | mm
(in.) |
- | - |
| *L | Length distance | - | - |