Measure points with the engine under No. 1 cover assembly, front suspension member lower protector, front floor cover and front fender liner removed.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Bolting point of front axle support on front section of body | M12 (0.47) |
| B, b | Bolting point of front axle support on centre section of body | M12 (0.47) |
| C, c | Bolting point of front axle support on rear section of body | M14 (0.55) |
| *a | mm
(in.) |
- | - |