Heat the double-sided tape remaining on the body with an infrared lamp or equivalent.
Heat the tape to 40 to 60°C for approximately 1 to 2 minutes.
Wipe off the remaining double-sided tape using a clean cloth or equivalent.
If a name plate is installed without thoroughly removing the remaining double-sided tape from the body, the name plate will not adhere properly. Make sure to thoroughly wipe off the double-sided tape.
After cleaning the installation area of the body with degreasing agent, attach the name plate to the position shown in the illustration.
The working environment should be 20°C when installing the name plate. If the working environment is below 20°C, heat the installation area of the body to 20 to 30°C and then install the name plate.
| *1 | FRONT BUMPER EMBLEM SUB-ASSEMBLY | - | - |
| ● | Non-reusable part | - | - |
| *1 | NO. 1 BACK DOOR EMBLEM | *2 | NO. 1 REAR NAME PLATE |
| *3 | NO. 1 BACK DOOR EMBLEM ASSEMBLY | *4 | NAME PLATE |
| ● | Non-reusable part | - | - |
NO. 1 BACK DOOR EMBLEM
| *a | Rear Bumper Assembly Edge |
| *b | Rear Bumper Assembly End of R |
| Area | Specified Condition |
|---|---|
| A | 40.9 mm (1.61 in.) |
| B | 91.6 mm (3.61 in.) |
| C | 84.6 mm (3.33 in.) |
NAME PLATE
| *a | Rear Bumper Assembly Edge | *b | Rear Bumper Assembly End of R |
| Area | Specified Condition |
|---|---|
| A | 65 mm (2.56 in.) |
| B | 40 mm (1.57 in.) |
| C | 131 mm (5.16 in.) |
| D | 138 mm (5.43 in.) |
NO. 1 REAR NAME PLATE
| *a | Rear Bumper Assembly Edge | *b | Rear Bumper Assembly End of R |
| Area | Specified Condition |
|---|---|
| A | 94 mm (3.70 in.) |
| B | 200 mm (7.87 in.) |
NO. 1 BACK DOOR EMBLEM
FRONT BUMPER EMBLEM SUB-ASSEMBLY