Home › Engine / Hybrid System › B58 (EMISSION CONTROL) › EMISSION CONTROL SYSTEM
NM3650E _51 Engine / Hybrid System _081436 B58 EMISSION CONTROL _0394314 EMISSION CONTROL SYSTEM GE GENERAL F

B58 EMISSION CONTROL  EMISSION CONTROL SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

By locating a wide range air fuel ratio sensor upstream of the 2 serially arranged Three-Way Catalytic (TWC) monoliths and an oxygen sensor between them, precise air-fuel ratio control and self-diagnosis of catalyst performance were made possible.


b.

By adopting the variable camshaft timing control of the intake and exhaust side camshafts, an internal Exhaust Gas Recirculation (EGR) system that proactively recirculates exhaust gases was realized.


c.

Canister purge control was implemented to prevent leakage of hydrocarbons from the fuel tank. This suppresses the release of fuel vapor.


d.

The tank leak diagnosis using Natural Vacuum Leak Detection (NVLD) takes place in the rest state after the vehicle is switched off. (Models with fuel temperature sensor)


e.

A mechanism for recirculation of blowby gas has been provided. While re-combusting the blowby gas that occurs during combustion, this produces a vacuum inside the crankcase. At this time, the oil contained within the blowby gas is separated using the oil trap.


f.

The TWC converter uses 2 monoliths mounted in series, contributing to reduced emissions.


g.

A Gasoline Particulate Filter (GPF) system is used for the models compliant with EURO 6d emission regulations to purify Particulate Matter (PM) contained in exhaust gas. (Models with GPF)


h.

When it is determined that vehicle maintenance is necessary, the indicator light for emissions inspection illuminates accordingly. (The maintenance pitch varies according to driving conditions.)