Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM
NM3650E _58 Vehicle Interior _081640 THEFT DETERRENT / KEYLESS ENTRY _0394967 ENTRY AND START SYSTEM CO CONTROL F

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM  CONTROL  ENTRY AND START CONTROL  


SYSTEM CONTROL


a.

The vehicle automatically detects the remote control at a distance of 1.5 m (4.92 ft.) when it is outside the vehicle or when it is in the interior.



FUNCTION


a.

Comfort Access

i.

For locking, the remote control must be outside of the vehicle in the area of the doors.


ii.

Repeated unlocking and locking is not possible until after approx. 2 seconds.


iii.

Fully grip the door handle of the driver's door or the door on the passenger side to unlock the vehicle doors.


iv.

Touch the surface on the door handle of the driver's door or the door on the passenger side with your finger for approx. 1 second, without gripping the door handle, to unlock or lock the vehicle doors.


v.

Conformation flashing and conformation buzzer are activated during locking or unlocking via the comfort access. *

HINT:

*: The setting of the light and the buzzer operation can be changed by means of Toyota Supra Command.




b.

Driving standby

i.

If the push start/stop button is pressed and the brake pedal is operated, with the electrical key transmitter sub-assembly placed inside the vehicle, the engine starts and the vehicle is put to the engine standby mode.


ii.

To deactivate the engine standby, shift the gear to the P position and then press the start/stop button.



c.

Vehicle drive standby in case the electrical key transmitter sub-assembly may not operate properly due to its battery being depleted etc.

i.

Unlock the door using the mechanical key.


ii.

Hold the back surface of the electrical key transmitter sub-assembly at the marked portion on the right side of the steering column. When the vehicle detects the electrical key transmitter sub-assembly, the key is indicated on the combination meter assembly.


iii.

If the electrical key transmitter sub-assembly continues to be detected, the vehicle will enter the drive standby mode and start the engine within approximately 10 seconds.