FUNCTION
Pedestrian Detection Sensor
Two pressure sensors are installed in the bumper and they are connected by a pressure hose. The pressure hose is a constituent part of the pedestrian detection sensor.
The pedestrian detection chamber assembly has the task of detecting an accident situation between a passenger car and a pedestrian and of selectively activating the system depending on certain marginal conditions.
The signals are evaluated in the airbag ECU assembly.
A force acting on the pressure hose alters this in its structure.
The compressed air volume causes a pressure increase at both pressure sensors (left pedestrian detection sensor and right pedestrian detection sensor).
Each pressure sensor transmits a pressure signal, which is dependent on the mass and rigidity of the impacting object, via a data line to the airbag ECU assembly.
The airbag ECU assembly analyses the characteristics of the signal and then makes a deployment decision as required.
If the pedestrian detection sensor fails, the function of the four-point pop-up hood system is blocked in the airbag ECU assembly.
The four-point pop-up hood system only triggers within a defined driving speed range. Outside of the defined road speed range, the function is disabled in the airbag ECU assembly.
| *1 | Pedestrian Detection Chamber Assembly | *2 | Pedestrian Detection Sensor |
| *a | Illustration is a representative example. | - | - |