CONSTRUCTION
Hood Lock Assembly
The hood lock assembly are components of the four-point pop-up hood system and are installed in the front right and front left hood lock assembly hinges.
If the airbag ECU assembly sends a trigger signal, the hood lock assembly trigger as follows:
The ignition squib in the pyrotechnic component ignites the propellant charge. The pyrotechnic actuator contains an ignition squib whose propellant charge shifts a plunger with bolt to unlock the hood sub-assembly catch.
After this unlocking, the cover and therefore the hood sub-assembly is raised by approximately 25 millimeters due to the force of the springs in the hood lock assembly within a few milliseconds.
| *1 | Hood Lock Assembly | *2 | Ignition Device |
| *a | Illustration is a typical example. | - | - |
Pop-up Hood Lifter Assembly
The pop-up hood lifter assembly are elements of the four-point pop-up hood system and are installed in the rear right and rear left hood sub-assembly hinges.
If the airbag ECU assembly sends a trigger signal, the pop-up hood lifter assembly triggers as follows:
The ignition squib in the pyrotechnic component ignites the propellant charge. The pyrotechnic actuator contains an ignition squib whose propellant charge shifts a plunger with bolt to unlock the hood sub-assembly catch.
After this unlocking, the cover and therefore the hood sub-assembly is raised by approximately 60 millimeters due to the force of the springs in the actuator within a few milliseconds.
| *1 | Pop-up Hood Lifter Assembly | *2 | Ignition Device |
| *a | Illustration is a typical example. | - | - |