FUNCTION
In the event of a collision with a pedestrian, the active pedestrian protection system raises the hood sub-assembly automatically to increase the deformation clearances and thereby reduce impact to the head of a pedestrian.
If there is a signal that equates to a collision with a pedestrian, the pop-up hood lifters are triggered to operate the active pedestrian control system.
The activated locks and hinges then move the hood sub-assembly up by 25 or 60 mm (0.98 or 2.36 in.) in the front and rear.
However, the activation only occurs at a driving speed of approx. 28-55 km/h (17-34 mph).
OPERATION
The four-point pop-up hood system has the task of detecting an accident situation between a passenger car and a pedestrian in the area of the hood sub-assembly and of selectively activating the system depending on certain marginal conditions.
The four-point pop-up hood system is a complete system comprising the following components.
Airbag ECU assembly
Pedestrian detection sensors (acceleration sensor), pedestrian detection chamber with optical fibers, installed in the front bumper panel.
Hood lock assembly (pop-up hood lifter RH)
Hood lock assembly (pop-up hood lifter LH)
Pop-up hood lifter Assembly RH
Pop-up hood lifter Assembly LH
If a collision with a pedestrian is registered by the pedestrian detection sensors, the airbag ECU assembly always triggers all the pop-up hood lifters. The triggering is pyrotechnical.
As a result the hood sub-assembly is raised a few millimeters at both the front and rear as a result of spring force.
This enlarges the space between the inner panel of the hood sub-assembly and the add-on parts to the engine as well as on the body.
The enlarged space increases the possible deformable area of the hood sub-assembly in the event of a head impact.
Furthermore, the rigid connection of the hood sub-assembly is changed into an elastic connection by the springs in the pop-up hood lifters. This enables improved energy dissipation when the head strikes the hood sub-assembly.
After the system has been triggered by a sensor signal, the hood sub-assembly can be reset.
Excess pressure on the opened hood sub-assembly (towards open) mechanically locks the pop-up hood lifter assemblies in the hood sub-assembly hinge, i.e.: the retaining bolts in the lid catch securely in the housing section of the pop-up hood lifter.
The spring force causes the mechanical system in the pyrotechnic component to return to its initial position (same as before triggering).
For renewed activation of the four-point pop-up hood system, replacement of the pop-up hood lifter is obligatory, as the ignition squib and propellant charge in the pyrotechnic component have been used up by the triggering.
The airbag ECU assembly is connected to the pop-up hood lifter assemblies via 2 signal lines.