OUTLINE
Depending on models, the clearance sonar system that uses ultrasonic sensors in the front and rear bumpers to detect obstacles has been adopted.
The clearance sonar system uses rear view camera to display obstacles on the rear view camera display.
The clearance sonar system which enables detection of obstacles at the side of the vehicle to support maneuvering such as when parking the vehicle has been adopted.
Ultrasonic sensors are used to detect obstacles. The ultrasonic sensors have a smaller diaphragm (favorable for design) and are painted for better appearance.
The ON/OFF switch for the clearance sonar system has been provided in the pattern select switch assembly on the center console.
PRECAUTION
In the following situations, the objects may not be detected due to the physical limit of the ultrasonic measurement:
A small child or animal
A pedestrian wearing certain types of clothing such as a coat
When ultrasonic waves are interfered with by noise caused by vehicles passing by or by machine operations
Soiled, frozen, damaged or improperly adjusted sensors
Under specific climate conditions such as high humidity, rain, snow, abnormally high temperatures, and strong wind
Towing bars or hooks of other vehicles
Thin objects or wedge shaped objects
Moving objects
A protruding object at a high position for example an emboss on a wall
An object with a sharp corner and edge with smooth surfaces.
An object with small surfaces and complex structures for example a fence
An object with many holes on the surface
A small and low object such as a box
An obstacle or person on the driving lane edge
A soft object or object covered with sponge material
Plants and bushes
An object at a low position such as a curbstone which has already been detected may come to the blind spot of the sensors before the consecutive buzzer sets off.
Luggage that protrudes from the vehicle is not considered in this system's functions.
In the following situations, an alert may be output even if no obstacle is present in the detection area:
Heavy rain
Severely soiled or frozen sensor
Sensor covered by snow
Uneven road surfaces
For example the roads with consecutive speed bumps to force vehicle deceleration
Inside a large square building surrounded by smooth walls (for example a basement garage)
When the vehicle enters a car wash
Severe emissions of exhaust gas
When there is any source of ultrasonic interference for example road sweepers, steam jet cleaners and neon lamps
To prevent alarms from being erroneously set off, the automatic switching on function for the clearance sonar system can be deactivated as necessary for example when obstacles are detected when entering a car wash.