Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › SFI SYSTEM
NM3650E _51 Engine / Hybrid System _081917 B58 ENGINE CONTROL _0395712 SFI SYSTEM CO CONTROL F

B58 ENGINE CONTROL  SFI SYSTEM  CONTROL  DIRECT FUEL INJECTION SYSTEM  


FUNCTION


a.

A direct injection system that injects fuel inside cylinders has been adopted.


b.

Fully-sequential multipoint injection with selective control for each individual cylinder offers the following advantages:

i.

Optimal fuel mixtures for each individual cylinder


ii.

The injection duration is precisely adapted to the engine's instantaneous operating conditions (engine speed, load factor and temperature)


iii.

Responds to changes in load by correcting the injection duration specifically for the individual cylinder (during the intake stroke the injection duration can be corrected with a supplementary post-injection discharge as well as by extending or reducing the injection period)


iv.

Selective deactivation of individual cylinders is also available (for instance, in response to a defective ignition coil)


v.

Diagnosis of each individual solenoid valve injector is possible.



c.

Fuel is injected into the combustion chambers during the intake and compression strokes. During the warm-up phase yet another, minute quantity of fuel is injected to assist the catalytic converter reach its effective operating temperature more quickly (catalytic converter heating).


d.

During cold starting the fuel is sprayed during the compression stroke in multiple pulses. This strategy provides reliable cold-starts along with substantive improvements in the areas of pollutant emissions and fuel consumption.


e.

The intake mass air flow meter sub-assembly detects the intake air mass and controls the fuel injection volume.


f.

The ECM controls the injection volume and the injection timing according to the engine speed and the engine load using the signals from each sensor.


g.

The multiple injection control, in which the fuel is injected separately in multiple times has been adopted.


h.

If the engine speed is higher than the specified value, fuel cutoff is conducted and fuel injection is stopped.