Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › SFI SYSTEM
NM3650E _51 Engine / Hybrid System _081917 B58 ENGINE CONTROL _0395712 SFI SYSTEM CO CONTROL F

B58 ENGINE CONTROL  SFI SYSTEM  CONTROL  VARIABLE VALVE TIMING CONTROL  


FUNCTION


a.

The variable camshaft timing control mechanism that continuously adjusts the camshaft positions has been adopted on the intake and the exhaust side to control the intake and exhaust valve timing according to the driving conditions.


b.

The variable camshaft timing control improves the torque in the lower and middle engine speed range. At the same time, the most favorable valve operation times for idle speed and maximum power output are adjusted.


c.

A smaller valve overlap results in lower amounts of residual gas at idle speed. The exhaust gas recirculation in the partial load range reduces the volume of nitrogen oxides. At idle speed, the camshafts are adjusted in such a way that there is a slight valve overlap to optimize consumption and operational smoothness. The smallest valve overlap is achieved with great to the greatest possible intake spread and the greatest possible exhaust spread.


d.

To achieve high torque at low engine speeds, the exhaust valves are opened late. This enables the expansion of combustion to move the piston for longer.


e.

At middle engine speeds, the exhaust valves are opened early to achieve high torque and reduce fuel consumption and emissions.


f.

At high engine speeds, the greater valve overlap (exhaust valve opening is advanced and exhaust valve opening is late) achieves high power output.


g.

The variable camshaft timing control and the fully variable valve lift control perform cooperative control.


h.

The variable camshaft timing control and the turbocharger control are cooperative. On the turbocharged engine, 'over-scavenging' - and thus significantly more torque - can be achieved at low engine speeds in the charged range with a positive scavenging divide by means of a large valve overlap. The effect:

i.

More air than is necessary for combustion flows through the engine. This means the compressor is not in the pump limit.


ii.

There is virtually no more residual gas in the cylinder.