Home › Engine / Hybrid System › B58 (ENGINE CONTROL) › SFI SYSTEM
NM3650E _51 Engine / Hybrid System _081917 B58 ENGINE CONTROL _0395712 SFI SYSTEM CO CONTROL F

B58 ENGINE CONTROL  SFI SYSTEM  CONTROL  CONTINUOUSLY VARIABLE VALVE LIFT CONTROL  


FUNCTION


a.

The fully variable valve lift mechanism has been adopted for the valve lift mechanism on the intake side. The fully variable valve lift control and the variable camshaft timing control enable continuously variable valve lift.


b.

The fully variable valve lift mechanism consists of a servomotor (camshaft timing oil control valve assembly), eccentric shaft (No. 3 camshaft sub-assembly) and the intermediate lever (tension arm sub-assembly). The ECM activates the servomotor (camshaft timing oil control valve assembly) at the cylinder head.


c.

The servomotor (camshaft timing oil control valve assembly) uses a worm gear to drive the eccentric shaft (No. 3 camshaft sub-assembly) and controls the valve lift.


d.

The servomotor (camshaft timing oil control valve assembly) contains the sensor for identifying the position of the eccentric shaft (No. 3 camshaft sub-assembly) and the brushless motor.

Valve Lift Amount
Valve Lift of the Intake Valve
Maximum 9.9 mm (0.394 in.)
Minimum 0.2 mm (0.008 in.)

Functions
Component Function
Servomotor (Camshaft Timing Oil Control Valve Assembly)
·

A brushless direct current motor* is used.

·

Contains the sensor for identifying the position of the eccentric shaft (No. 3 camshaft sub-assembly).

·

Surrounded by engine oil and an oil spray nozzle ensures that the worm gear for the eccentric shaft (No. 3 camshaft sub-assembly) is lubricated.


Eccentric Shaft (No. 3 Camshaft Sub-assembly) An electrically-adjustable eccentric shaft (No. 3 camshaft sub-assembly) changes the action of the camshaft on the roller cam follower via an intermediate lever (tension arm sub-assembly). The result of this is variable valve lift.
Intermediate Lever (Tension Arm Sub-assembly) The operating axis changes depending on the angle of the eccentric shaft (No. 3 camshaft sub-assembly), and variates the No. 1 valve rocker arm sub-assembly movement.
ECM Controls the drive of the servomotor (camshaft timing oil control valve assembly) based on the signals from the sensors.

HINT:

*: In a brushless direct current motor without commutator, an alternating magnetic field creates a targeted attraction and rejection between the rotor and stator, which sets the electrical machine in motion. When switched on, the south pole of the magnetic field generated in the stator attracts the north pole of the magnet in the rotor. Before the north pole of the rotor reaches the south pole of the stator, the magnetic field around the south pole is switched to the next phase. This causes the rotor to continue to turn. The rotor thereby follows the successively changing magnetic fields around the stator. The rotational movement of the rotor transfers the mechanical energy for the drive.




SYSTEM CONTROL


a.

The ECM calculates the associated position of the fully variable valve lift mechanism using the position of the accelerator pedal and other variable signals.


b.

A servomotor (camshaft timing oil control valve assembly) activates the fully variable valve lift mechanism to control the valve lift.


c.

By cooperative control with the variable camshaft timing control, the fully variable valve lift control has achieved early intake valve closing at low load and thus ensured reduction of consumption and emission.


d.

The valve gear consists of the fully variable valve lift mechanism and the variable camshaft timing mechanism, which enables a free choice of closing time for the intake valve.


e.

In order to achieve the correct valve opening, an adaptation must be made to balance all tolerances in the valve gear.