CONSTRUCTION
An exhaust pipe with wire-brushed stainless finish has been adopted.
A decoupler is located downstream of the catalytic converter housing.
An electrically driven exhaust flap (actuator with bracket assembly) is integrated into the tail exhaust pipe assembly, so that noise emissions are reduced when idling or driving at low RPM ranges.
The electrically driven exhaust flap (actuator with bracket assembly) is controlled by the ECM, and actuated by an electronically controlled motor which is positioned in the axial direction.
The electrically driven exhaust flap (actuator with bracket assembly) can be toggled between the fully open and fully closed positions only, and cannot be stopped in an intermediate position.
| *a | Electrically Driven Exhaust Flap (Actuator with Bracket Assembly) | *b | The illustrations shown are examples only. |