Home › Engine / Hybrid System › B48 (ENGINE CONTROL) › SFI SYSTEM
NM3650E _51 Engine / Hybrid System _081734 B48 ENGINE CONTROL _0395336 SFI SYSTEM CO CONTROL F

B48 ENGINE CONTROL  SFI SYSTEM  CONTROL  ENGINE CONTROL  


FUNCTION OF MAIN COMPONENTS


a.

The main sensors of the engine control system are as follows:

Component Function and Structures
Intake Mass Air Flow Meter Sub-assembly Detects the amount of air passing through, as well as the direction of flow.
Camshaft Position Sensor (for Intake Camshaft) Detects the position of the intake camshaft sub-assembly.
Camshaft Position Sensor (for Exhaust Camshaft) Detects the position of the exhaust camshaft sub-assembly.
Crank Position Sensor Detects the angle and rotation speed of the crankshaft.
Accelerator Pedal Sensor Assembly Registers accelerator-pedal position and then transmits driver demand to the engine-management control unit in the form of electrical signals.
Engine Coolant Temperature Sensor (for Engine) Detects the temperature of the coolant.
Engine Coolant Temperature Sensor (for Radiator) Detects the temperature of the coolant after the radiator assembly.
Fuel Pressure Sensor Detects the fuel pressure after high pressure pumping.
Wide Range Air Fuel Ratio Sensor Measures residual oxygen in the exhaust gas.
Oxygen Sensor Used by a special diagnostic function for catalytic converter monitoring.
Vacuum Sensor Assembly Detects the charge air temperature and vacuum pressure at the intake manifold after the throttle butterfly valve.
Intake Air Temperature Sensor Detects the charge air temperature before the turbocharger.
Air Pressure Sensor Delivers the absolute pressure (sum of charging pressure and ambient pressure of the charging air to the ECM.
Knock Control Sensor Detects the structure-borne sound vibrations and monitors knocking of all cylinders.
Oil Pressure Sensor Calculates the absolute pressure of the engine oil.
Engine Oil Level Sensor Measures the engine oil level and engine oil temperatures.
No. 1 Fuel Tank Breather Tube Pressure Sensor Detects the pressure in the purge line.


b.

The main actuators of the engine control system are as follows:

Component Function and Structures
Fuel Pump Control ECU The speed of the fuel suction tube with pump and gauge assembly is controlled by signals sent from the ECM through the brushless three phase motor.
Fuel Suction Tube with Pump and Gauge Assembly Delivers fuel from the fuel tank to the fuel pump assembly.
Fuel Pump Assembly Flow Quantity Control Valve The valve increases fuel pressure delivered from the fuel suction tube with pump and gauge assembly and delivers the required quantity of fuel in accordance with the control signals from the ECM.
Fuel Injector Assembly Injects the high-pressure fuel to the combustion chamber in accordance with the injection signals from the ECM.
Ignition Coil Assembly Ignites the fuel mixture in accordance with the ignition signals from the ECM.
Cam Timing Oil Control Solenoid Assembly (for Intake Camshaft) Drives the intake camshaft timing gear bolt assembly by the signals from the ECM.
Cam Timing Oil Control Solenoid Assembly (for Exhaust Camshaft) Drives the exhaust camshaft timing gear bolt assembly by the signals from the ECM.
Servomotor (Camshaft Timing Oil Control Valve Assembly) Changes the action of the intake camshaft sub-assembly on the roller cam and thus achieves a variable cam lift.
Turbocharger Actuator and Link Assembly Electrical Wastegate Valve The charging pressure of the turbocharger is regulated by the ECM via an electric wastegate valve.
Throttle Body with Motor Assembly Opens and closes based on the signals from the ECM.
Fuel Tank Breather Valve Is closed while the engine is stopped to prevent fuel vapor from flowing into the intake manifold.
Ventilation Hose Blowby Gas Heater Prevents the accumulated condensed water in the No. 2 air cleaner hose from freezing.