Home › Vehicle Exterior › MIRROR (EXT) › MIRROR SYSTEM
NM3650E _59 Vehicle Exterior _082878 MIRROR (EXT) _0399815 MIRROR SYSTEM CO CONTROL F

MIRROR (EXT)  MIRROR SYSTEM  CONTROL  MIRROR CONTROL  


SYSTEM CONTROL


a.

Outer Rear View Mirror Adjustment

i.

A mirror adjustment request is sent from the power window regulator master switch assembly.


ii.

Adjustment of the outer rear view mirror assembly can be performed from the outer mirror switch of the power window regulator master switch assembly. Toggling between the driver side and passenger side is performed using the outer mirror switch. Horizontal and vertical adjustment are performed independently.


iii.

The outer rear view mirror assemblies cannot be adjusted while they are in a folded state.


iv.

If an electrical malfunction occurs, the mirrors can be adjusted manually by pressing the edges of the mirror glass.



b.

Mirror Memory (Models with Power Seat)

i.

The mirror memory uses 2 potentiometers to detect the intermediate positioning of the mirrors, which is sent to the outer rear view mirror assembly and stored. This enables targeted movements to these intermediate positions (such as automatically pointing downward, etc.)



c.

Folding Outer Rear View Mirrors

i.

A mirror folding request is sent from the power window regulator master switch assembly.


ii.

Folding the outer rear view mirror assemblies is performed from the power window regulator master switch assembly.


iii.

The signals from the mirror folding button are sent via the LIN bus from the power window regulator master switch assembly to the applicable outer rear view mirror assemblies and control the folding motors.



d.

Electrochromic Door Mirror Dimming

i.

A dimming request signal is sent from the inner rear view mirror assembly.


ii.

When a light source from a following vehicle is detected, the outer rear view mirror assemblies and inner rear view mirror assembly are dimmed automatically. The level of dimming will vary depending on how dazzling the light source is.


iii.

Control signals are sent from the inner rear view mirror assembly via the Main Body ECU (Multiplex Network Body ECU) to the outer rear view mirror assemblies.



e.

Reverse-linked Function

i.

A request signal is sent from the Main Body ECU (Multiplex Network Body ECU) via the LIN bus to the applicable outer rear view mirror assemblies.


ii.

When parking, to improve visibility of the curb and other nearby obstacles, the passenger side outer rear view mirror assembly is rotated downward after the vehicle is shifted into reverse gear.