Home › Power Source / Network › NETWORKING › ETHERNET COMMUNICATION SYSTEM
NM3650E _57 Power Source / Network _082879 NETWORKING _0399819 ETHERNET COMMUNICATION SYSTEM GE GENERAL F

NETWORKING  ETHERNET COMMUNICATION SYSTEM  GENERAL  GENERAL  


OUTLINE


a.

Ethernet is a manufacturer-neutral, cable-bound network technology. The protocols TCP/IP (Transmission Control Protocol/ Internet Protocol) and UDP (User Datagram Protocol) are used as transfer protocols.


b.

The "Open Alliance BroadR-Reach" (OABR Ethernet) standard has been developed as the new data transfer layer especially for use in motor vehicles.


c.

OABR Ethernet supports bidirectional 100 MBit/s communication between two nodes. Consequently, both nodes can simultaneously send with a data transfer rate of 100 MBit/s. OABR Ethernet requires networking from point to point. Ethernet switches are used to link new nodes. Stub lines or similar components are consequently not necessary. Ethernet switches have currently been integrated into the following control units:

i.

Main body ECU (multiplex network body ECU)


ii.

Radio receiver assembly


iii.

Forward recognition camera


iv.

Ethernet switch*

*: Models with Ethernet Switch




d.

In the event of Ethernet switch failure, any linked bus users are disconnected from the network and are no longer able to communicate via Ethernet.