CONSTRUCTION
The outside temperature sensor (temperature sensor assembly) measures the ambient temperature for all systems in the vehicle that require the ambient temperature.
The outside temperature sensor (temperature sensor assembly) signal is processed in the combination meter assembly. The combination meter assembly transmits the signal on the CAN bus.
The combination meter assembly transmits a damped outside temperature value. This means that with the help of a computation model in the combination meter assembly, the effect of the residual heat from the engine compartment on the temperature signal of the outside temperature sensor (temperature sensor assembly) is compensated for. The increase in temperature is delayed. The input variables for the calculation model are as follows:
Driving speed
Coolant temperature
Engine status (running or stopped)
Ambient temperature
When the ambient temperature becomes low, the value is adopted without damping because the engine and body would not become colder than the ambient temperature.
In normal operation, the ambient temperature is calculated at regular intervals of once per second.
After terminal 15 is switched off, the ambient temperature is calculated every 20 minutes for a maximum of 24 hours.
The outside temperature value is displayed on the liquid crystal display of the combination meter assembly.
The outside temperature sensor (temperature sensor assembly) is a precision thermistor or NTC (Negative Temperature Coefficient) resistor.
NTC resistors convert temperature values into resistance values, which can then be evaluated electronically. The conductive materials in the NTC resistor conduct current better at high temperatures than at low temperatures. In other words, the hotter the NTC resistor gets, the lower its resistance becomes.
Under certain circumstances, an incorrect display of the ambient temperature is physically unavoidable.
Under certain driving conditions, the display deviates from the real value due to damping action. In the event of a customer complaint, this behavior must be explained as a technical limitation.
| *1 | Outside Temperature Sensor (Temperature Sensor Assembly) | *2 | 2-pin Plug Connection |
| *a | Illustration shows a representative example. | - | - |