Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
NM3650E _53 Suspension _082916 TIRE PRESSURE MONITORING _0400077 TIRE PRESSURE WARNING SYSTEM CO CONTROL F

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  CONTROL  TIRE PRESSURE WARNING CONTROL  


FUNCTION OF MAIN COMPONENTS


COMPONENTS FUNCTION
Brake Actuator Assembly Skid Control ECU Processes the remote control receiver receives the radio signals from the tire pressure monitor valve sub-assemblies.
Remote Control Receiver Transmits the wireless signal received from the tire pressure monitor valve sub-assembly to the brake actuator assembly via the CAN communication line.
Tire Pressure Monitor Valve Sub-assembly Installed to each wheel rim and transmits the following signals when the vehicle has exceeded a set speed.
·

Tire pressure

·

Tire air temperature

·

Remaining service life of the battery

·

Data from the acceleration sensor and identification Feature (ID) of the tire pressure monitor valve sub-assembly

·

Transmission mode (passive, standby, learning)


Combination Meter Assembly When loss of tire inflation pressure is detected, the warning light on the multi information display inside the combination meter assembly indicates it.
Multi-display Assembly
·

The details of the tire pressures are displayed.

·

The tire pressure monitor valve sub-assembly is initialized.




SYSTEM CONTROL


a.

The tire pressure warning system has now been integrated in the skid control ECU. The remote control receiver receives the radio signals from the tire pressure monitor valve sub-assembly. The remote control receiver is connected to the main body ECU (multiplex network body ECU) via the CAN bus. The main body ECU (multiplex network body ECU) transmits the signal to the brake actuator assembly via the bus connection.


b.

The multi-display assembly functions of the tire pressure warning system are controlled by the skid control ECU.


c.

The skid control ECU transmits the information to the combination meter assembly and the multi-display assembly. When loss of inflation pressure is detected, the warning light on the combination meter assembly and a message on the multi-display assembly indicates it. Other information related to tire pressure can be checked on the multi-display assembly from the vehicle status menu.


d.

The remote control receiver is being used as reception aerials to receive up-to-date tire pressure and tire temperature readings from the tire pressure monitor valve sub-assembly installed in each of the 4 tires fitted to the vehicle.


e.

The tire pressure control software integrated in the Vehicle Stability Control (VSC) system evaluates these signals sent from the wheel (tire pressure monitor valve sub-assembly) together with the ABS signals and sends the information for combination meter assembly and in the multi-display assembly

NOTICE:
·

The displayed set pressure values must thereby always be adhered to when correcting the tire inflation pressure to ensure that the tire pressure control is functioning correctly.

·

Only the tire dimension of the rear axle must be selected under the tire settings for each tire change.

·

The last summer or winter tire that was used is stored in the tire settings to simplify the annual changeover between summer and winter tires.





FUNCTION


a.

Warning function

i.

The driver is informed of the tire pressure conditions in three levels as follows.

Level Item Explanation
1 Tire pressure warning You can continue driving. Tire pressure slightly lowered. Fill tire at the next available opportunity.
2 Slow tire pressure loss They can be driven further at maximum 130 km/h (80 mph). Tire pressure too low. Check the pressure in all the tires and fill them at the next available opportunity.
3 Abrupt tire pressure loss Tire pressure abruptly lowered. Stop carefully.