Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
NM3650E _53 Suspension _082916 TIRE PRESSURE MONITORING _0400077 TIRE PRESSURE WARNING SYSTEM DE DETAILS F

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  DETAILS  TIRE PRESSURE WARNING VALVE AND TRANSMITTER  


CONSTRUCTION


a.

In all wheels, tire pressure monitor valve sub-assembly is bolted onto the filling valves (made of metal).


b.

All tire pressure monitor valve sub-assemblies are same parts.


c.

Each tire pressure monitor valve sub-assembly unit incorporates an acceleration sensor. The acceleration sensor recognizes whether the wheel is stationary or rotating. When the wheels are stationary the remote receiver does not transmit messages to the Vehicle Stability Control (VSC).


d.

Once the vehicle reaches 30 km/h (18 mph) the tire pressure monitor valve sub-assembly switch to their "standby" mode. The tire pressure monitor valve sub-assemblies start to transmit in defined cycles.


e.

The tire pressure monitor valve sub-assemblies measure the tire inflation pressure and the temperature at regular periodic intervals. The remote control receiver relays these monitored data from the tire to the Vehicle Stability Control (VSC) in periodic cycles. The brake actuator assembly relies on the identification number that accompanies the transmissions to assign the information to individual wheels.


f.

The messages of the tire pressure monitor valve sub-assembly are transmitted via a high-frequency transmission path to the remote control receiver. The tire pressure monitor valve sub-assembly measures the tire inflation pressure and the temperature at regular periodic intervals. The measured values are transmitted by each set number of measurements to the remote control receiver. The signals are forwarded on the CAN bus to the brake actuator assembly. The brake actuator assembly evaluates the signals.