FUNCTION OF MAIN COMPONENTS
| Components | Function | |
|---|---|---|
| Power Steering Gear Assembly (for Rack and Pinion) | Power Steering ECU | ·
Calculates the necessary steering assist amount. ·
Uses a speed-dependent variable assist torque system. |
| Torque Sensor | Detects the steering force applied by the driver. | |
| Adjust motor with Rotor Position Sensor | ·
Generates assist torque using a brushless DC synchronous motor in order to assist the driver and perform compensation. ·
Sends steering angle information to the power steering ECU. |
|
| Reduction Gear | Transmits adjust motor output to the rack bar. | |
| Brake Actuator Assembly | Skid Control ECU | ·
Sends speed signal from the speed sensors to the power steering ECU. ·
Sends Vehicle Stability Control (VSC) coordination signals to the power steering ECU. |
| ECM | Sends engine speed signals. | |
| Combination Meter Assembly | Illuminates the indicator light if there is a malfunction in the electric power steering system. | |
| Multi Display Assembly | Displays a warning message if there is a malfunction in the electric power steering system. | |
SYSTEM CONTROL
Steering Assist
Assist and damping characteristic mappings are saved in the power steering ECU. The necessary steering assist amount is calculated using values and characteristic curves calculated from the various signals.
The following input signals are needed for steering assist control:
Vehicle speed
Steering force applied by the driver, as detected by the torque sensor
Information from skid control ECU, ECM, speed sensors, etc.
Operating temperature
When the driver needs to be warned about system conditions, a warning is transmitted as steering vibration from the steering vibrator (steering wheel motor) or from the electric power steering system.
The system assists in returning the steering wheel angle to the centered position. This improves vehicle handling, especially at low speed.
Information about the road surface, such as frictional coefficient, roughness, etc., is transmitted to the driver in appropriate ways through steering behavior.
FAIL-SAFE
If abnormally high voltage is detected in the battery, the power steering ECU terminates steering assist and displays a warning message. If the high voltage situation is resolved, the steering assist restarts and the warning message disappears.
If the voltage of the battery becomes low, the power steering ECU gradually reduces the steering assist amount, and a warning message is displayed. If the voltage drops below a specified level, steering assist is terminated. If the low voltage situation is resolved, the steering assist restarts and the warning message disappears.
As part of thermal protection, the power steering ECU adjusts the steering assist amount according to temperature.
Before the electric power steering system reaches the mechanical operating limits, the software function sets left and right stop positions. The stop positions are determined based on the following signals.
Steering angle
Steering rotation speed