Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
NM3650E _55 Steering _082921 POWER ASSIST SYSTEMS _0400086 POWER STEERING SYSTEM DE DETAILS F

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  DETAILS  POWER STEERING MOTOR  


CONSTRUCTION


a.

The servomotor with rotor position sensor is a DC synchronous motor. The assist torque from the servomotor with rotor position sensor is transmitted through the reduction gear to the rack bar.


b.

Inside the power steering ECU there are 2 rotor position sensors with magnetic wheels. The angle of the servomotor is detected by the No. 1 rotor position sensor, and an estimated value of the steering angle is calculated. The signal from the No. 2 rotor position sensor is compared against the estimated value. The power steering ECU supplies voltage to the 2 sensors.


c.

The reduction gear consists of a toothed belt driving a ball screw. The servomotor with rotor position sensor drives the toothed belt, and the toothed belt drives the ball screw. The ball screw includes countermeasures to reduce noise.