FUNCTION
The electric parking brake control is implemented in the skid control ECU and can be operated via the electric parking brake switch assembly located in the center console, which is connected via a LIN bus.
The electric parking brake control unit decides if all conditions for actuation have been met.
If the required operating conditions have been met, the 2 parking brake actuator assemblies in the rear disc brake cylinder assemblies are activated. The braking force is maintained through the self-locking mechanism on the spindle and the vehicle is held securely, even when the power is switched off.
Once the required braking force is achieved, the braked state is indicated by a red indicator in the combination meter assembly and an additional red LED in the electric parking brake switch assembly.
The electric parking brake can be released manually or automatically. Automatic release is performed when the following preconditions have been met and the accelerator pedal is depressed.
The vehicle is capable of being driven.
Selector lever is in the D or R position.
The driver's seat belt is fastened and the driver door is closed.