Home › Brake › BRAKE (REAR) › REAR BRAKE
NM3650E _54 Brake _082983 BRAKE (REAR) _0400275 REAR BRAKE DE DETAILS F

BRAKE (REAR)  REAR BRAKE  DETAILS  BRAKE CALIPER  


CONSTRUCTION


a.

RA Brake Caliper (Rear Disc Brake Cylinder Assembly):

i.

Single-piston floating rear disc brake cylinder assembly with parking brake function integrated in the caliper.



b.

Sport Brake Caliper (Rear Disc Brake Cylinder Assembly) (Models with Red Sport Brake):

i.

High thermal performance is achieved in conjunction with effective brake cooling.

X130217C01
1.521,2.948 1.833,3.104 0.313,0.156 10 false *a 5.125,2.927 5.438,3.083 0.313,0.156 10 false *b 0.125,3.5 0.438,3.698 0.313,0.198 10 false *c
*a 17" eUL *b 17" e
*c The illustrations shown are examples only. - -




c.

Brake Pad Wear Indicator

i.

Simplification of brake pad wear indicator through Condition Based Repair (CBR):

·

CBS information is continually displayed at all times in the service needs menu (multi-display assembly).

·

CBR information is added to the multi-display assembly on an "event-controlled" basis, after contact is made with the brake pad wear sensor (pad wear indicator wire assembly) at a defined brake pad thickness.

·

Until the sensor is activated, no information about the state of the brake pad is output on the multi-display assembly.

·

When contact is made with the sensor, the remaining mileage can be called up and is displayed in the service needs menu.



ii.

Determination of the brake pad thickness and calculation of the remaining mileage before it will need changing depending on the customer's typical driving style. Indicator according to customer's specific information needs.


iii.

Each inner brake pad of the front left and rear right wheel brake is fitted with a brake pad wear sensor (pad wear indicator wire assembly). Until the sensor is activated, no information about the state of the brake pad is output (Phase 1). During looping through of the sensor, the remaining distance for each axle is calculated in a calculation model that is implemented in the skid control ECU based on the current customer-specific driving style in correlation with the vehicle parameters (Phase 2+3) and displayed in the multi-display assembly.

·

When the remaining mileage is < 2000 km (1250 miles), the CBR indicator is activated in yellow.

·

When the remaining mileage is < 0 km (0 mile), the red brake warning light on the combination meter assembly is also activated.

·

The text message of the CBR display then changes from "Service due in..." to "Service due since...".



iv.

The front brake pad light or rear brake pad light illuminates when it has been determined that vehicle maintenance is necessary. (The maintenance pitch varies according to driving conditions.)