FUNCTION
Electronically controlled limited slip differential
The electronically controlled limited slip differential controls the multiplate wet clutch of the rear differential carrier assembly according to driving conditions to generate locking torque between the left and right drive shafts.
The multiplate wet clutch is operated by a motor driven by the differential lock ECU.
The motor includes 2 sensors to detect the position of the clutch. The sensor signals are sent to the differential lock ECU.
If the motor temperature rises and reaches a specified level, generation of locking torque is stopped and the mechanism operates as a normal differential.
If a malfunction is detected in the multiplate wet clutch, the motor loosens the multiplate wet clutch and stops locking torque control, the mechanism operates as a normal differential.
The electronically controlled limited slip differential operates in the following circumstances:
When the vehicle is starting to move.
When the engine brake causes stable lateral acceleration.
When the road surfaces under the left and right wheels have different coefficients of friction and the wheels are turning at different speeds.
During high-speed cornering.
When drifting.
Differential Lock ECU
The differential lock ECU uses signals sent from the Vehicle Stability Control (VSC) and other systems to calculate the driving conditions.
Communication with other systems is performed via FlexRay.
The unit calculates the necessary locking torque.
Controls the actuator of the rear differential carrier assembly to generate locking torque in the multiplate wet clutch.
If the differential lock ECU temperature rises and reaches a specified level, generation of locking torque is stopped and the mechanism operates as a normal differential.