Home › Power Source / Network › B48 (BATTERY / CHARGING) › CHARGING SYSTEM
NM3650E _57 Power Source / Network _082986 B48 BATTERY / CHARGING _0400290 CHARGING SYSTEM CO CONTROL F

B48 BATTERY / CHARGING  CHARGING SYSTEM  CONTROL  CHARGING CONTROL  


SYSTEM CONTROL


a.

The generator assembly is controlled by the ECM.


b.

For the generator assembly with a serial data interface, the following items are controlled by the ECM:

i.

Switching the generator assembly on and off on the basis of defined parameters


ii.

Output control



c.

The target voltage value of the battery and the necessary generator charging voltage value to achieve that target are determined by the ECM, which manages minimum and maximum voltages while balancing the electrical consumption of the various electrical devices in the vehicle to prevent excessive load on the battery and perform charging effectively.


d.

The target voltage value is controlled according to the following elements.

i.

The temperature of the battery is related to the necessary charging voltage; when the battery temperature is low, the battery takes in comparatively less current for a given charging voltage, so it is necessary to increase the charging voltage. The temperature of the battery is detected by the battery state sensor assembly, which sends it to the ECM via LIN communication.


ii.

To protect the battery, excessive charging voltage is restrained, and when the battery state of charge becomes low, the continued discharge of the battery is also restrained.


iii.

To avoid having functionality restricted or stopped, the minimum and maximum voltages are controlled so as to remain within the range required by the various electrical devices in the vehicle.



e.

When the engine is being started or when the various electrical devices in the vehicle are drawing excessive electrical load, to protect the battery from discharge, the various electrical devices are shut off or their power consumption is restricted. Also, even when power consumption restriction is in effect, the operation messages and indicators of the various electronic devices continue to be displayed.


f.

While idling, if the load on the generator assembly has increased, or if the power consumption has increased, etc., and the battery needs to be charged, the ECM raises the engine idling speed in order to increase the generator assembly output.


g.

When the vehicle is being decelerated by braking, or is coasting, etc., the dynamic energy of the vehicle is regenerated in the battery. This energy is used when accelerating. This helps reduce the vehicle's fuel consumption and carbon dioxide emissions.