Home › Brake › BRAKE (FRONT) › FRONT BRAKE (except 4-Pot Caliper)
RM3650E _54 Brake _079879 BRAKE (FRONT) _0387541 FRONT BRAKE(except 4-Pot Caliper) A

BRAKE (FRONT)  FRONT BRAKE(except 4-Pot Caliper)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE FRONT DISC BRAKE PISTON

a.
C415908

Carefully push out the front disc brake piston (2) through the connecting bore using compressed air.

CAUTION:

In this process, do not hold the front disc brake piston (2) with your fingers as there is a pinch hazard.



b.

Insert a protective plate (1) (e.g. made of hardwood or a rubber part) into the brake caliper housing to protect the brake piston.


c.
C415910

Push off the cylinder boot (1).


Hide 2.REMOVE PISTON SEAL

a.
C415909

Carefully remove the piston seal (1).


b.

Clean the cylinder of the front disc brake cylinder and the front disc brake piston and dry with compressed air.


c.

Check the cylinder of the front disc brake cylinder, the front disc brake piston and the flange surface for damage, if necessary, replace the front disc brake cylinder.

NOTICE:

Do not remove material from cylinders and front disc brake pistons during processing.