Home › Brake › BRAKE (FRONT) › FRONT BRAKE (except 4-Pot Caliper)
RM3650E _54 Brake _079879 BRAKE (FRONT) _0387541 FRONT BRAKE(except 4-Pot Caliper) A

BRAKE (FRONT)  FRONT BRAKE(except 4-Pot Caliper)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL PISTON SEAL

a.
C415909

Insert the piston seal (1).


b.

Lightly coat the cylinder of the front disc brake cylinder, the front disc brake piston and the piston seal with Syntheso Glep 1 Lubricating Grease.


Hide 2.INSTALL FRONT DISC BRAKE PISTON

a.
C415911

Insert the cylinder boot into the annular groove of the front disc brake piston (2).

NOTICE:

In this process, the front disc brake piston (2) must not tilt.



b.

Press in the front disc brake piston (2) into the cylinder of the front disc brake cylinder.


c.

Evenly push the cylinder boot (1) onto the front disc brake cylinder up to the limit position.

NOTICE:
·

To guarantee that the cylinder boot fits perfectly: Keep the area between the cylinder boot and the front disc brake cylinder dry.

-

Keep the area between the cylinder boot and the front disc brake cylinder dry.

-

Keep Syntheso Glep 1 Lubricating Grease or brake fluid away from the area between the cylinder boot and the front disc brake cylinder.