Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for 4-Pot Caliper)
RM3650E _54 Brake _079879 BRAKE (FRONT) _0387542 FRONT BRAKE(for 4-Pot Caliper) A

BRAKE (FRONT)  FRONT BRAKE(for 4-Pot Caliper)  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE FRONT DISC BRAKE PISTON

a.
C415164

Position protective plate (e.g. Made of hardwood, hardened felt or rubber) (1) in front disc brake cylinder (2).

CAUTION:

In this process, do not hold the front disc brake piston (4) with your fingers as there is a pinch hazard.



b.

Position air gun (3) on the connecting bore of the front disc brake cylinder (2).


c.

Carefully push out the front disc brake piston (4) with compressed air in direction of arrow and remove.


d.
C415165

Remove cylinder boot (1) from the front disc brake cylinder (2).


Hide 2.REMOVE PISTON SEAL

a.
C415166

Carefully remove piston seal (1) from the front disc brake cylinder (2).


b.
C415167

Clean the cylinder of the front disc brake cylinder, the piston seal (2) and the front disc brake pistons (3) and dry with compressed air.


c.

Check the cylinder of the front disc brake cylinder (4), the piston seal (2), the front disc brake pistons (3) and the flange surfaces for damage, if necessary, replace the front disc brake cylinder (4).

NOTICE:

Any processing of the cylinder of the front disc brake cylinder (4) and the front disc brake brake piston (3) is not allowed.