Home › Brake › BRAKE (FRONT) › FRONT BRAKE (for 4-Pot Caliper)
RM3650E _54 Brake _079879 BRAKE (FRONT) _0387542 FRONT BRAKE(for 4-Pot Caliper) A

BRAKE (FRONT)  FRONT BRAKE(for 4-Pot Caliper)  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL PISTON SEAL

a.
C415167

Clean the cylinder of the front disc brake cylinder, the piston seal (2) and the front disc brake pistons (3) and dry with compressed air.


b.

Check the cylinder of the front disc brake cylinder (4), the piston seal (2), the front disc brake pistons (3) and the flange surfaces for damage, if necessary, replace the front disc brake cylinder (4).

NOTICE:

Any processing of the cylinder of the front disc brake cylinder (4) and the front disc brake brake piston (3) is not allowed.



c.

Lightly coat the cylinder of the front disc brake cylinder (4), the piston seal (2) and the front disc brake pistons (3) with Syntheso Glep 1 Lubricating Grease.


d.
C415166

Install piston seal (1) into the front disc brake cylinder (2).


Hide 2.INSTALL FRONT DISC BRAKE PISTON

a.
C415168

Slide cylinder boot (1) onto the front disc brake pistons (2).


b.

Press in the front disc brake piston (2) into the cylinder of the front disc brake cylinder. In this process, the front disc brake pistons (2) must not tilt.


c.
C415169

Insert cylinder boot (1) into the respective annular groove (2) of the front disc brake piston.


d.

Evenly push the cylinder boots (1) into the respective groove (3) in the direction of arrow on the front disc brake cylinder up to the limit position.

NOTICE:
·

To guarantee that the cylinder boots (1) fit perfectly:

-

Keep the areas between the cylinder boots (1) and the front disc brake cylinder dry.

-

The areas between the cylinder boots (1) and the front disc brake cylinder must not come in contact with the lubricating grease or brake fluid.