Home › Brake › BRAKE (REAR) › REAR BRAKE
RM3650E _54 Brake _079883 BRAKE (REAR) _0387572 REAR BRAKE A

BRAKE (REAR)  REAR BRAKE  REASSEMBLY  


PROCEDURE

Hide 1.INSTALL CYLINDER BOOT

a.
C409010

Clean the contact surface of the cylinder boot on the rear disc brake cylinder assembly (1) and on the annular groove (2) of the brake piston using a lint-free cloth.


b.

Carefully check the cylinder of the rear disc brake cylinder assembly and the rear disc brake piston for damage.

NOTICE:
·

Corroded or damaged components must be replaced.

·

To guarantee that the cylinder boot fits perfectly:

-

Keep the area between the cylinder boot and the rear disc brake cylinder assembly dry.





c.
C409014

Pull the sealing lip (1) of the cylinder boot (2) over the rear disc brake piston until the cylinder boot (2) is completely fitted into the annular groove of the rear disc brake piston.


d.

Position the cylinder boot (2) evenly on the contact surface of the rear disc brake cylinder assembly and push in evenly.

NOTICE:

The cylinder boot must fit correctly around the entire circumference of the rear disc brake cylinder assembly and on the annular groove of the rear disc brake piston.