Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ACTUATOR
RM3650E _54 Brake _079884 PARKING BRAKE _0387581 ELECTRIC PARKING BRAKE ACTUATOR A

PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

After completing repair work:

-

Use the parking brake button to open, close and open the parking brake again.




HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.PERFORM REAR BRAKE PAD REPLACEMENT MODE

a.

Connect the diagnosis system with the vehicle.


b.

Determine the workshop mode.

Vehicle management / Service functions / Chassis / Parking brake / Workshop mode


c.

Disconnect the diagnosis system from the vehicle.


Hide 2.RELEASE PARKING BRAKE

a.

Release parking brake.


b.

Turn the START-STOP button (engine switch) off.

HINT:
·
A439562

Pressing and holding the AUDIO button changes the power source mode to IG OFF.

·

The START-STOP button (engine switch) off must be switched off for at least 30 seconds before the plug connection is disconnected.




c.

Disconnect plug connection.


Hide 3.REMOVE PARKING BRAKE ACTUATOR ASSEMBLY

a.
C413640

Unlock plug connection (1) and disconnect.


b.

Detach the rear flexible hose from the holder (2).


c.

Detach the cable from the holder (2).


d.
C413641

Release the 5 mm hexagon bolts (1) and remove the holder (2).


e.
C413642

Remove the parking brake actuator assembly (1) in the direction of the arrow.