Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ACTUATOR
RM3650E _54 Brake _079884 PARKING BRAKE _0387581 ELECTRIC PARKING BRAKE ACTUATOR A

PARKING BRAKE  ELECTRIC PARKING BRAKE ACTUATOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.INSTALL PARKING BRAKE ACTUATOR ASSEMBLY

a.
C413643

Lightly coat the sealing ring (1) with brake fluid.

HINT:
·

When reusing the parking brake actuator assembly:

-

Check the sealing ring (1) for damage and replace where required.





b.
C413644

Carefully position the parking brake actuator assembly (1).

NOTICE:
·

The gearing must engage.

·

Make sure that the parking brake actuator assembly rests flush against the rear disc brake cylinder assembly.



HINT:

If necessary, turn the parking brake actuator assembly slightly until the bore hole and the screw thread are aligned.



c.
C413641

Position holder (2).


d.

Tighten the 5 mm hexagon bolts (1).

Torque:
9.5 N*m (97 kgf*cm, 84 in.*lbf)


e.

Connect connectors and lock.


f.

Attach the rear flexible hose in the holder.


g.

Attach the cable in the holder.


Hide 2. NORMAL CONDITION RECOVERY

a.

Connect the diagnosis system with the vehicle.


b.

Cancel the workshop mode.

Vehicle management / Service functions / Chassis / Parking brake / Workshop mode


c.

Disconnect the diagnosis system from the vehicle.


Hide 3. CARRY OUT A BRAKE TEST OF THE PARKING BRAKE ON THE BRAKE TEST STAND

a.
C420465

Position the vehicle with its rear axle on the brake test stand.


b.

Position the selector lever in selector lever position N (neutral).


c.

Run engine at idle speed.

i.

The brake test stand starts automatically.


ii.

The control unit runs a plausibility check (comparison of wheel speed) to identify within a few seconds that a vehicle is on the brake test stand and changes to brake test stand mode.


iii.

If brake test stand mode has been activated and the EMF actuators are open, the indicator light for the electromechanical parking brake (EMF) flashes slowly.



d.
C413603

Press the parking brake button (1) to apply the brake pads.

i.

When brake test stand mode is active and the EMF actuators have been partly applied, the indicator light for the electromechanical parking brake (EMF) flashes quickly.



e.

Press the parking brake button (1) for the brake test with test force 1.


f.

Press the parking brake button (1) for the brake test with test force 2.


g.

Press the parking brake button (1) for the brake test with test force 3.


h.

Read the maximum brake forces on the left and right.


i.

Release the parking brake button (1).

i.

This releases the parking brake.



j.

Move the vehicle from the brake test stand.

i.

Brake test stand mode is automatically quit upon driving off the brake test stand.



k.

After having completed the brake tests: Perform terminal change.

i.

All indicator lights go out after having completed the terminal change.