87050C
1.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (M9)
Overview of No. 1 air conditioning radiator damper servo sub-assembly:
Disconnect the connector (3).
Remove T20 screws (2).
Remove No. 1 air conditioning radiator damper servo sub-assembly (M9) (1).
87208F
2.REMOVE WATER PIPE SUB-ASSEMBLY
Remove mounting plate (1).
Remove the seals (1) from the pipes (2) and remove them completely.
Remove T20 screw (1).
Disengage claws (1) and remove the water pipe sub-assembly holder.
Turn the water pipe sub-assembly (1) downwards in the direction of the arrow.
Remove retaining clip (1) as in following operation.
Use the same procedure as for the opposite side.
Disengage retaining clip (1) using screwdriver upwards.
Slide retaining clip (2) using screwdriver to one side.
Remove the 2 water pipe sub-assemblies.
Remove the 2 O-rings.
87107A
3.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
Remove T20 screws (1).
Remove the heater radiator unit sub-assembly (2).
88501
4.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove T20 screw (1).
Disconnect the cable (2) from the guides (arrows) and place to one side.
Disengage the claws (1).
Remove T20 screws (2).
Remove T20 screws (1).
Remove the blower housing (2) slightly and disengage from the hooks (3).
Remove T20 screws (1).
Disengage the claw (1).
Disengage the claws (1).
Remove T20 screws (2).
Disengage the claws (1) and guide out the lower radiator case sub-assembly (2) and remove it.
Remove the No. 1 cooler evaporator sub-assembly (1) with the seal (2) from the air conditioning radiator assembly (3).