Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING UNIT (for LHD)
RM3650E _58 Vehicle Interior _079885 HEATING / AIR CONDITIONING _0387587 AIR CONDITIONING UNIT(for LHD) A

HEATING / AIR CONDITIONING  AIR CONDITIONING UNIT(for LHD)  REASSEMBLY  


PROCEDURE

Hide 88501 1.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

a.
I114284

Install the No. 1 cooler evaporator sub-assembly (1) in the air conditioning radiator assembly (3) correctly.

HINT:

Make sure that the seal (2) is positioned correctly.



b.
I114283

Correctly feed in lower radiator case sub-assembly (2) and engage at the claws (1).


c.
I114282

Engage claws (1).


d.

Tighten T20 screws (2).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


e.
I114281

Engage claw (1).


f.
I114278

Tighten the T20 screws (1).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


g.
I114277

Install blower housing (2) onto the hooks (3) and position correctly.


h.

Tighten the T20 screws (1).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


i.
I114276

Engage claws (1).


j.

Tighten T20 screws (2).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


k.
I114275

Connect cable (2) at the guides (arrows).


l.

Tighten T20 screw (1).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


Hide 87107A 2.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

a.
I114291

Install heater radiator unit sub-assembly (2).


b.

Tighten the T20 screws (1).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


Hide 87208F 3.INSTALL WATER PIPE SUB-ASSEMBLY

a.

Replace the 2 O-rings.


b.

Connect the 2 water pipe sub-assemblies.


c.
I114287

Secure the water pipe sub-assembly with the retaining clip (1).

HINT:

Use the same procedure as for the opposite side.



d.
I114852

Turn the water pipe sub-assembly (1) back to their original position in the direction of the arrow.


e.
I114280

Install the water pipe sub-assembly holder and engage the claws (1).


f.
I114850

Tighten T20 screw (1).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


g.
I114279

Thread the seals (1) completely over the pipes (2) and position them correctly.


h.
I114849

Install mounting plate (1).


Hide 87050C 4.INSTALL NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (M9)

a.
I114848

Install the No. 1 air conditioning radiator damper servo sub-assembly (M9) (1).


b.

Tighten T20 screws (2).

Torque:
1.2 N*m (12 kgf*cm, 11 in.*lbf)


c.

Connect the connector (3).