Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM3650E _59 Vehicle Exterior _079886 WIPER / WASHER _0387610 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


PROCEDURE

Hide 89941 1.INSTALL RAIN SENSOR

NOTICE:
·

Damage to silicone surface.

A damaged silicone surface can lead to malfunctioning of the rain sensor.

-

Do not touch or damage the silicone-coated surface on the rain sensor.




HINT:

After releasing lock, wait approx. 30 minutes. at 20°C (68°F) for silicone surface to relax.


a.
B536829

Check silicone surface (1) for damage.

HINT:
·

Silicone surface (1) is damaged.

-

Replace rain sensor.





b.
B536830

Carefully clean windshield glass in the contact area (1) of rain sensor.


c.
B536828

Install the rain sensor (2) into the holder and press on centered on the retaining springs (1).


d.

Successively press down the retaining springs (1) on each side to lock it.


e.
B536831

Check contact surfaces for air pockets from the outside.

HINT:
·

Visible shadows (1) are not air pockets, but the optical element of the rain sensor (2).

·

The shadows (1) do not indicate a functional limitation.

·

Contact surface has air pockets.

-

Remove the rain sensor and install again.





f.

Connect the connector.


Hide 87810 2.INSTALL INNER REAR VIEW MIRROR ASSEMBLY