Home › General › SPECIFICATIONS › DRIVE SHAFT / PROPELLER SHAFT
RM3650E _V1 General _079878 SPECIFICATIONS _0387624 DRIVE SHAFT / PROPELLER SHAFT F

SPECIFICATIONS  DRIVE SHAFT / PROPELLER SHAFT  TORQUE SPECIFICATIONS  


Rear Drive Shaft Assembly
Part Tightened N*m kgf*cm ft.*lbf
Rear drive shaft assembly x Wheel bearing 1st 210 2141 155
2nd Turn 90°

Propeller Shaft Assembly
Part Tightened N*m kgf*cm ft.*lbf in.*lbf
Flexible coupling x Propeller shaft assembly with center bearing 1st 55 561 41
2nd Turn 90°
Flexible coupling x Three-hole frange 1st 55 561 41
2nd Turn 90°
Center mount x Body 21.4 218 16
Front floor cover LH x Body 3.0 31 27
Front floor cover RH x Body 3.0 31 2
Front No. 1 floor heat insulator x Body Screw 2.6 27 23
Nut 3.0 31 27
Insert nut 100 1020 74