Use the same procedure for LHD and RHD vehicles.
The following procedure is for LHD vehicles.
55981
1.REMOVE NO. 1 DEFROSTER NOZZLE GARNISH
|
Protective Tape |
Apply protective tape as shown in the illustration.
Using a molding remover D, detach the clips (2) and claws (1) to remove the No. 1 defroster nozzle garnish (3).
73960A
2.REMOVE INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY
55084E
3.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Peel off the adhesive tape (1).
Detach the guides (2) to remove the No. 1 heater to register duct sub-assembly (1).
55085
4.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
Use the same procedure as for the No. 1 side.
55312
5.REMOVE INSTRUMENT LOWER PANEL
Loosen T20 screws (1).
Detach the guides (2) to remove the instrument lower panel (3).