Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM3650E _59 Vehicle Exterior _079908 LIGHTING (EXT) _0387828 AUTOMATIC LIGHT CONTROL SENSOR A

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  REMOVAL  


PROCEDURE

Hide 87810 1.REMOVE INNER REAR VIEW MIRROR ASSEMBLY

Hide 89941 2.REMOVE RAIN SENSOR

NOTICE:

When replacing windshield glass: Immediately install the rain sensor on the new windshield glass.


a.
B536827

Disconnect the connector (1).


b.
B536828

Push in retaining springs (1) on both sides and disengage the lock by means of a screwdriver.

NOTICE:
·

Damage to silicone surface.

A damaged silicone surface can lead to malfunctioning of the rain sensor (2).

-

Do not touch or damage the silicone-coated surface on the rain sensor (2).





c.
B536829

Remove the rain sensor slowly off the windshield glass. At the same time, monitor the release of the silicone area (1) from outside.

NOTICE:

The silicone surface must evenly loosen from the windshield glass, if applicable, lower the pull-off force.


HINT:

After releasing lock, wait approx. 30 minutes. at 20°C (68°F) for silicone surface to relax.