Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
48520
1.DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY
Fully extend the front shock absorber assembly.
Secure the front shock absorber assembly horizontally in a vise with the piston rod pulled out.
| *a | 140 mm (5.51 in.) |
Wearing protective glasses, extend the piston rod and cover it with a cloth. At position B, located 140 mm (5.51 in.) from position A shown in the illustration, use a metal saw to cut a hole and release the gas.
Always use proper safety equipment and be careful when drilling because shards of metal way fly about.
The gas is colorless, odorless and non-poisonous.