Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
48540
1.DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY
Fully extend the rear shock absorber assembly.
Secure the rear shock absorber assembly horizontally in a vise with the piston rod pulled out.
| *a | 50.0 mm (1.97 in.) |
Wearing protective glasses, extend the piston rod and cover it with a cloth. At position B, located 50.0 mm (1.97 in.) from position A shown in the illustration, use a metal saw to cut a hole and release the gas.
Always use proper safety equipment and be careful when drilling because shards of metal way fly about.
The gas is colorless, odorless and non-poisonous.